The Energedry ELE 6400

Revolutionized the Restoration Industry

Now the Energedry Eliminator Is the

Next Generation Heater

Energedry  Eliminator Series- Thermal Evaporative Accelerator
• Outperform Dehumidifiers 100% of the time • Works on 115v circuit or 230v splitter with “Ramp Up” power feature that keeps more circuits available for airmovers • up to 96F temperature rise capability allow for proper temperature control in positive, neutral or negative pressures • Digital thermostat w/12’ cable measures temperatures from within the drying or tented area for accurate control of drying temperature • Heavy duty construction, durability & thermostat with 12’ cord and modular plug.

The Eliminator is NEC ® compliant using standard 15amp household breaker

With the Energedry Eliminator you will get the job done fast.  Drying with this system, dehumidification is not needed in most cases, but can be added in some drying situations for even faster drying.

It's a fact of drying that warmer air can hold more water vapor. At 70°F, air can hold twice the moisture of air at 50°F. This particular difference of twenty degrees means that you can evaporate twice the moisture from structural materials. Use the Energedry Eliminator to create "thirsty" air with greater moisture-carrying capacity. The Energedry Eliminator is the most powerful Industry specific electric heat drying system that is totally self-contained and thermostatically controlled. Custom ramp up power feature allows for less energy consumption without compromising performance. Dry walls, carpet, wood floors, cabinets, etc... with ease.

The Eliminator In Action

ELE 6400 Is Putting Heated Air Into the Squirrel Fan Side of the Air Mover. The Air Mover is Pushing the Heated Air Into the Ceiling Cavity. The Thermostat Probe Is Put Into the Ceiling Cavity. This Gives the Actual Temperature Inside the Ceiling Cavity. Using 2 Heating Elements We Were Able To Get the Temperature Was 110° In About 15 Minutes

Beware of Distributors that Offer the ELE 6400

The ELE 6400 has Been Discontinued Since September 2009 and Has Not Been Available from the Manufacture Since September 2009.

Using the Eliminator and a Air Mover to Float Carpet (Heat Drying). We used 2 circuits of the Eliminator. We ducted the heat through Mylar ducting to the squirrel fan (air intake) side of a air mover. The thermostat sensor was on top of the carpet, but you can also put the sensor under the carpet. The sensor and thermostat are a very important part of heat drying. The thermostat allows us to control the heat used to dry the carpet, padding and subfloor.

October 2010 Special

Buy 2 Eliminator (R)’s for $3,798.00 with FREE Shipping. You Save $200.00

(Some Restrictions May Apply)

Please Note: The Eliminator (R) or (RM) Are Not Designed for Pest Control. If Used for Pest Control This Voids the Warranty. The Eliminator (R) or (RM) Are Designed for Restoration Use.

Check Out the Eliminator (R) On ebay

Click Here

The Eliminator (R) Now Comes with A

25’ Section of Mylar Ducting

The New Improved Eliminator (R) Now Comes with 4 Sockets for the Extension Cords. 2 On the Right Side and 2 On the Left Side

The New Improved Eliminator (R) Does Not  Come with Pigtails Shown In This Picture